Program
Files - PC Files
Model ZoomAccess2 -7502 and ZoomAccess8 -7508
The Blaster Program is used to program the firmware on ZoomAccess
and TribeLink products. The MSDLC protocol must be installed
on Windows for the Blaster program to work. Winblast will
work in W95/98/ME. The DOS version is also available for
download. When you run Winblast, you must step through the
screen until you see the word "Flash" on the screen. Before
hitting the word Flash, you will need to go back one screen
and then go forward again or else the program will not run
properly.
ZoomAccess2 -7502
 |
The
Latest System Firmware
Update (.exe
file) for the ZoomAccess2 unit. This can be
used with the Blaster program. |
|
Boot
image (.exe file) can be upgraded through the
Blaster program. You can also upgrade the boot image
through WebManage. Instructions as follows:
- Connect ZoomAccess to Webmanage.
- Enter URL of the browser of the ZoomAccess 2 IP
address followed by "secret" i.e. xxx.xxx.x.xx/secret.
- This should display the HTME page where the option
to upgrade the Boot rom is available.
|
ZoomAccess 8 - 7508
Mac Files
ZoomAccess2 -7502 and
ZoomAccess8 -7508
|
Mac Blast (.hqx
file) This is the utility for programming the firmware
on a ZoomAccess unit. MacBlast might not work in OS versions
later than 7.5.5 due to changes in Open Transport. |
ZoomAccess2 - 7502
|
